The TEXELL range of high performance joint fillers offer the widest choice of closed cell polyethylene foam available. Including low and high densities, cross linked and non-cross linked materials they offer a clean, easy and efficient method of forming expansion voids in brickwork, blockwork and concrete.

LOW DENSITY JOINT FILLERS

All TEXELL low density joint fillers are ideal for use in brickwork and blockwork due to their low compressive strengths. Also ideal for expansion and isolation joints in concrete slab construction. They are specified, therefore, in the construction of hardstandings, factories and warehouses, community and commercial buildings, airports and military bases etc.

FEATURES Light, clean and easy to store and handle Closed cell construction, stops absorption of water Easy and quick to cut on-site Excellent recovery after compression Weather, alkali and acid resistant Low load transfer Can be supplied in any cut size Available in 10, 12, 15, 20, & 25mm as standard Can be split or heat laminated between 1mm & 500mm Tear-off edge for removal prior to sealing, if required Available with adhesive coating one side protected by a peel-off silicone liner Suitable also for use with most polyurethane contact adhesives

TECHNICAL DATA & COMPLIANCE

LOW DENSITY JOINTFILLERS

All materials are fully compliant with the following: D.O.T specification for highway works Part 3 clause 1015 BS5268 Part 3: 1985 Section 20.4 for movement joints in brickwork.

TEXELL 1 has been tested by the Water Research Council and are registered under the bylaws scheme for use with potable water.